Filter
Top Products
Operation
3-14 975-0057-01-01
To inflate your vehicle, motorcycle, or bicycle tires:
1. Place the valve connector securely on the tire valve stem,
push it as far as possible to allow normal airflow, and
close the thumb latch. If necessary, use a supplied nozzle
adapter.
2. Turn the compressor on, and inflate your tire to the
recommended pressure. Use Table: Pressure
Specifications for Common Items as a guide only.
3. Turn the compressor off after appropriate pressure is
reached.
4. Open the thumb latch and remove the valve connector
from the valve stem.
5. Check air pressure with a pressure gauge.
Note: The information in the table is for reference only.
For precise pressure specifications, refer to the information
supplied with the article to be inflated.
CAUTION
If the pressure gauge on the compressor indicates more than
twice the recommended pressure for the object you are
inflating, and you have only started to inflate the object, the
valve connector is incorrectly connected to the valve stem.
This may damage the XPower Powerpack 400 Plus. Remove
and reattach the valve connector to the valve stem.
Note: Leave the thumb latch in the open position for
storing to relieve pressure on the internal mechanisms.
XPower 400 Powerpack Plus.book Page 14 Thursday, October 20, 2005 12:58 PM