Filter
Top Products
Replacing the Internal Battery
32
Before attempting to replace the internal battery, make sure
that:
• You disconnect any charging cables, 12 volt DC
appliances, or AC appliances from the Jazz PP 300 C.
• You turn off the AC Outlet On/Off switch and turn off
the fluorescent light switch.
• You remove the jump-start cables.
To replace the battery:
1. Place the Jazz PP 300 C upright on a stable and level
surface.
2. Unscrew the four fasteners that hold the compressor unit
on the back of Jazz PP 300 C. Place the fasteners in the
cover for safe keeping.
3. Disconnect the wires on the battery only.
4. After removing the old battery, position the new battery
close to the back of the Jazz PP 300 C.
WARNING
If you do not know how to safely remove and install
batteries, have this task performed by a qualified service
technician.
WARNING
When installing the replacement battery, make sure the
battery polarity is correct. Reverse polarity will damage
the Jazz PP 300 C and could cause serious injury.
Important:
Do not disconnect the wires on the main frame of
the Jazz PP 300 C.
Jazz 300.book Page 32 Thursday, February 28, 2002 11:36 AM