Filter
Top Products
Recharging the Jazz PP 300 C Battery
28
Recharging with the DC Charging Cable
Using the DC Charging Cable, the Jazz PP 300 C can be
recharged while you drive your vehicle.
To recharge the Jazz PP 300 C while you drive using the
DC Charging Cable:
1. While the vehicle engine is running, plug one end of the
DC Charging Cable into the DC Power Socket of the Jazz
PP 300 C.
2. Plug the opposite end of the DC Charging Cable into the
vehicle’s lighter socket or 12 volt accessory outlet.
3. Once the Jazz PP 300 C is fully charged or if your
vehicle’s engine is not running, disconnect the DC
Charging Cable from both sockets.
Most of the Jazz PP 300 C’s capacity will be restored in
four hours while the vehicle engine is running.
Important:
Although the charge regulation circuitry in Jazz
PP 300 C does not operate with this charging method, most
vehicle voltage regulators will ensure that the Jazz PP 300 C is not
overcharged.
CAUTION
Do not use this recharging method if your vehicle has
abnormally high voltage electrical systems that operate
above 15 volts DC.
CAUTION
While Jazz PP 300 C is being recharged with the DC
Charging Cable from your vehicle, do not operate AC
appliances.
Note:
The Recharge indicator will not turn green when the Jazz
PP 300 C is recharged through the DC Charging Cable.
Jazz 300.book Page 28 Thursday, February 28, 2002 11:36 AM