Filter
Top Products
Assembly 25
MAN0458 (9/23/2005)
INSTALL SMV SIGN
1. Attach SMV (Slow Moving Vehicle) socket (93) to
SMV emblem bracket (71) using two carriage bolts
(97) and lock nuts (30). See Figure 18 and Figure
19.
2. Attach SMV sign (98) to SMV bracket (94) using
two cap screws (95) and lock nuts (96).
3. Insert SMV sign into socket.
Figure 18. SMV Socket Installed
Figure 19. SMV Sign Installation
INSTALL DISCHARGE TUBE (OPTIONAL)
1. Remove discharge cap from chipper. Save all
hardware.
Figure 20. Remove Discharge Cap
2. Remove 5/16 NC nylock nuts and washers from
the studs on the discharge cap.
3. Slide 5/16 studs on discharge tube assembly into
slots on chipper housing.
4. Attach previously removed 5/16 NC nylock nuts
and washers on studs.
5. Align chip deflector with lower hole of chipper
housing and install 3/8 NC x 5-1/2" cap screw, two
3/8" flat washers, and 3/8" lock nut. Make sure cap
screw goes through tube on the bottom of the chip
deflector. Chipper deflector must be pointing
upward to allow discharge material to flow through
discharge tube.
Figure 21. Chipper Deflector, Pointing Upward
6. Install second 3/8 NC x 5-1/2" cap screw, two 3/8"
flat washers, and 3/8" lock nut in the top hole.
93
94
97
96
30
95
98
71
CD6758-1
30. 5/16 NC Lock nut
71. SMV Emblem bracket
93. SMV Socket
94. SMV Bracket
95. 1/4 NC x 3/4 Cap screw
96. 1/4 NC Nylock nut
97. 5/16 NC x 3/4 Carriage bolt
98. SMV Sign
DP11
Studs
Discharge
Cap
Chipper
Deflector Tube