Filter
Top Products
11
ENGLISHFRANÇAISEESPAÑOL
(2) DC APPLICATION (See Fig.
44
-
rr
)
The DC terminal is used only for charging 12 volt batteries.
It provides up to 12V-8.3A (100W) of maximum power.
q Positive terminal (RED)
w Negative terminal (BLACK)
CONNECTION OF CABLE :
Connect positive terminal (red) on generator to positive (+) terminal on battery.
Connect negative terminal (black) on generator to negative (-) terminal on battery.
SAFETY PRECAUTIONS WHILE CHARGING
An explosive hydrogen gas is discharged through vent holes in the battery during the charging process.
Do not allow spark or open flame around the generator or battery during the charging process.
Electrolyte fluid can burn eyes and clothing.
Be extremely careful to avoid contact. If injured, wash the affected area immediately with large
quantities of water and consult a doctor for treatment.
When charging a large capacity battery or totally discharged battery, excessive current may force
the DC out.
In such cases, use a battery charger to charge a large battery with AC output.
FUSE REPLACEMENT (See Fig.
44
-
tt
)
If a fuse burns out, check for the cause of trouble, and make the necessary repairs before installing the
new fuse.
q FUSE
Be sure to use the correct fuse. An incorrect fuse may cause damage to the generator.
The fuse rating for DC output is 10A.
(e) Turn on the switch of the appliance.
NOTE
When the AC circuit breaker turns off during operation, the generator is over loaded or the appliance is defective.
Stop the generator immediately, check the appliance and / or generator for overloading, and have repaired
as necessary by Robin dealer or service shop.
Do not put foreign objects into the plug receptacle.
CAUTION