Filter
Top Products
COMPONENTS
(See Fig.
11
)
PRE-OPERATION CHECKS
(See Fig.
22
)
Please refer to the illustrations on the back
page of
the front cover or back cover for
Fig.
11
to
55
indicated in the sentence.
NOTE
q CONTROL PANEL
w FUEL TANK
e FUEL GAUGE
r TANK CAP
t AIR CLEANER
y FUEL COCK
u OIL GAUGE (OIL FILLER)
i SPEED ADJUSTER
o OIL FILTER
!0 OIL DRAIN PLUG
!1 FUEL FILTER
!2 RECOIL STARTER
!3 RECOIL STARTER HANDLE
!4 MUFFLER
!5 ELECTRIC STARTER
5
ENGLISHFRANÇAISEESPAÑOL
1. CHECK ENGINE OIL
(See Fig.
22
-
qq
thru
ee
)
Oil quality
Qualified are all trademark oils which fulfil at least
one of the following specifications:
ACEA – B2 / E2 or more significant
API – CD / CE / CF / CF-4 / CG-4 or more
significant.
If engine oil of a poorer quality is used, reduce oil
change intervals to 150 hours of operation.
Oil viscosity (See Fig.
22
-
qq
)
Select the viscosity class according to the ambient
temperature for cold starts.
When adding oil or checking the oil level, the engine
must be horizontal.
Remove oil filler screw and add engine oil.
(See Fig. 2-w)
To check the oil level, remove the dipstick, clean
it - then screw it back in and finally remove it
again.
Check the oil level on the dipstick and, if
necessary, top up to the max. level.
(See Fig. 2-e)
RGD3300H . . . . . . . . . . . . . . . . . . . . 1.1
RGD5000H . . . . . . . . . . . . . . . . . . . . 1.5
Oil capacity (Upper level) :
(L)
2. CHECK FUEL
Stop the engine before refilling the fuel
tank. Never refuel near a naked flame or
sparks which could start a fire.
Don't smoke.
Use only pure fuel and clean filling
equipment.
Take care not to spill fuel.
WARNING
CONTROL PANEL
a AC RECEPTACLES (20A)
b VOLTMETER
c FULL POWER SWITCH
d DC FUSE
e AC CIRCUIT BREAKER
f HOUR METER
g KEY SWITCH
h GROUND TERMINAL
i DC TERMINALS
j AC RECEPTACLES (30A)