Filter
Top Products
10
ENGLISHFRANÇAISEESPAÑOL
NOTE
If no generating condition is found out,
please consult nearest ROBIN dealer.
Check the voltmeter for proper voltage.
(approx.120V).
2. USING ELECTRIC POWER
(1) AC APPLICATION (See Fig.
44
-
qq
,
ww
)
(a) Check the voltmeter for proper voltage. (approx.120V).
This generator is thoroughly tested and adjusted in the factory.
If the generator does not produce the specified voltage, consult your nearest Robin dealer or service shop.
(b) Turn off the switch(es) of the electrical appliance(s) before connecting to the generator.
(c) Insert the plug(s) of the electrical appliance(s) into the receptacle. (See Fig. 4-q)
Check the amperage of the receptacles
used referring to TABLE 1, and be sure not to take a current
exceeding the specified amperage.
Be sure that the total wattage of all appliances dose not exceed the rated output of the generator.
(d) Turn the
AC circuit breaker
to the position ON. (See Fig. 4-w)
Up to 20A
Style Ampere
NEMA
5-20R
Receptacle
NEMA
5-20P
AC plug
GFCI (Ground Fault
Circuit Interrupter)
Receptacle, duplex
Up to 20A
NEMA
L14-20R
NEMA
L14-20P
Locking Receptacle
Up to 30A
NEMA
5-30R
NEMA
5-30P
Locking Receptacle
Description
TABLE 1
To take power out from the TWIST LOCK RECEPTACLE, insert the plug into the
receptacle, and turn it clockwise to the lock position. (See Fig.
44
-
ee
)
Be sure to ground the generator if the connected electrical device is grounded.
WARNING
Make sure that the appliance is switched OFF before connecting it to the generator.
Do not move the generator while it is running.
Be sure to ground the generator if the connected appliance is grounded. Failure to
ground unit may lead to electrical shock.
WARNING