Filter
Top Products
– 44 –
(4) Inserting the rope.
(this should be done by two people)
-1 Thread the rope through the reel where the rope
hole on the reel and rope guide are aligned.
-2 Thread the rope end through the rope guide and
the rope hole of the reel, and pull 20cm out from
the reel.
-3 Tight the end of the rope.
(5) Keep pressure on the spring
-1 Feed the rope .(the length of one rotation of the
reel) from the attached hole of the reel and pull it
out from teh hole of the case.
On the reel side, let the rope that was pulled out
hang over the notch of the reel.
About 20cm
About 10mm
Rope
Cut of the reel
Pull off hole
Fixed hole