Filter
Top Products
– 40 –
Tightening torque : 3.0
-
4.0 N m
30
-
40 kgf cm
(2.2
-
2.9 ft lbs)
5-4-24
Rear cover
Attach the rear cover to the case body.
M6 x 30
Screw and Washer
: 4pcs.
Rear cover
5-4-25 Side panels (left and right)
Attach the side panel (left and right) to the case body.
M6 x 16.5mm Bolt : 2pcs.
Side Panel
This is the end of assembly procedures.
5-4-23 Choke wire and rolling wire
Set adjusting screw onto Choke wire bracket and
fix nut.
Fit choke wire with screw at choke lever swivel.
Install the rolling wire into the wire plate and fuel cock
behind the control panel.
Rolling
wire
Choke wire Choke wire
bracket
Wire
Nut
Adjusting screw
Choke wire
NOTE: Make sure the carburetor chock is closed
when turning the engine
switch into CHOKE position.
Also make sure the choke is fully opened
when turning the engine switch into RUN
position.