Filter
Top Products
– 23 –
5-3) DISASSEMBLY PROCEDURES
Please disassemble in the order of the procedure below.
5-3-1 Remove the side panels (Left, Right)
Remove the side panels.
M6 16.5mm Bolt 2 pcs.
Tools : Screw driver
Side Panel
5-3-2 Remove the rear cover
Remove the rear cover by unscrewing the four screws.
M6 20mm
Screw
and Washer 4pcs.
Tools : Screw driver
Rear cover
5-3-3 Remove rolling wire, choke wire
Remove chock lever swivel screw fixing chock wire.
Untighten adjusting screw nut, remove adjust screw from
chock wire bracket, and then take out choke wire from
swivel.
Unwind the rolling wire by hand or pliers, and pull up.
Tools : Screw driver, pliers
Rolling
wire
Choke wire Choke wire
bracket
Wire
Nut
Adjusting screw
Choke wire