Filter
Top Products
23
Normal Installation
5. Remove the bypass hose (Figure 41) from the cross-
over tubes.
See Figure 42.
6. Connect the 23/32” x 40” hoses (B) from the control
valve to the the cross-over tubes (A).
7. Connect the 1/2” x 75” hoses (C) from the control
valve to the dozer hoses (D).
8. Lubricate the dozer as shown in the Maintenance
section of this manual.
9. Perform all adjustments as shown in the Adjustments
section of this manual.
Figure 42. Connect Hydraulic Hoses
A. Cross-Over Tubes
B. 23/32” Control Valve Hoses
C. 1/2” Control Valve Hoses
D. 1/2” Dozer Blade Hoses
A
B
D
C
Figure 41. Remove Bypass Hose
Do Not Kink
Bypass Hose