Filter
Top Products
20
Initial Assemble & Installation
Figure 32. Transmission Fluid Check
A. Hydraulic Tube
Figure 33. Transmission Oil Fill
Transmission
Oil Fill
Bumper Removed For Clarity
10. Install a male and female quick connector on the 1/2”
x 11” hose (see Figure 31). This hose must be
installed when the dozer blade is removed from the
tractor.
Figure 31. Assemble Bypass Hose
Female
Quick
Connector
1/2” x 11” Hose
Male
Quick
Connector
11. Start the unit and check for leaks.
12. Run the unit for at least 10 minutes and move the
blade from side to side 10 times to bleed air out of
the hydraulic system.
13. Check the oil level. Observe the oil level in the plas-
tic tube at the rear of the unit (see Figure 32).
There should be 1” to 1-1/2” of oil in the tube. If there
is no oil in the tube add Type-F automatic transmis-
sion oil a few ounces at a time. The transmission fill
tube is located under the seat (see Figure 33).
IMPORTANT NOTE
After removing the dozer blade, do not
operate the tractor without first
installing the bypass hose (Figure 31).
A
B