Filter
Top Products
-
51
-
10-3-9 FRONT PANEL
Mount the front panel assembly to the frame.
Refer to Section 10-4 for disassembly, checking and reassembly procedures of the front panel.
(1) Connect the wires from the front panel and
the engine.
(2) Connect the wires drawn out from the stator to
the wires from the front panel.
NOTE : Connect the wires of the same color.
(3) Press the upper end of the bushing into the
bottom window of the front panel.
(4) Mount the front panel to the frame.
M5 x 12 mm bolt and washer Ass’y . . . 2 pcs.
M5 x 25 mm bolt and washer Ass’y . . . 2 pcs.
10-4 CHECKING, DISASSEMBLY and REASSEMBLY of the FRONT PANEL
10-4-1 CHECKING OF THE FRONT PANEL
Dismount the front panel from frame. Remove the control panel and check each components and wiring.
Refer to Section 9 for the detail of checking procedure for the components in the front panel.
10-4-2 DISASSEMBLY
(1) Remove the control panel from the front panel.
M4 screw . . . 6 pcs. (RGV2800, RGV4100)
M4 screw . . . 7 pcs. (RGV6100)
(2) Disconnect the connectors on the wires to detach the control panel and front panel.
(3) Remove the condensers and diode rectifier from the front panel.
(4) After disconnecting individual wires, remove the control panel components.
NOTE : Full power switch and pilot lamp have their wires soldered. Unsolder them to remove those parts
if necessary.
Fig. 10-31