Filter
Top Products
-
48
-
10-3-5 END COVER (RGV4100 only)
Attach the end cover to the rear cover.
10-3-6 FRAME
(1) Attach the mount rubbers to the frame. Insert
the setting tongue of mount rubber into the hole
on the frame and tighten the nut from the bot-
tom of the frame.
M8 flange nut . . . 4 pcs.
NOTE : The mount rubbers are selected to reduce vibration most effectively by model. Be sure to use
the correct mount rubber for your generator. Although mount rubbers have the same appear-
ance, their characteristics are different.
(2) Attach the 5 mm terminal of the grounding wires (green / yellow) to the unpainted thread hole of the
frame base plate using a 5 mm brass screw.
(3) Install the engine and alternator assembly into
the frame. Put the engine and alternator as-
sembly into the frame from the side of it.
Tighten the nuts over the mount rubber bolts
to fix.
M8 nuts . . . 4 pcs.
NOTE : Remove the air cleaner cover for easier installation.
NOTE : When tightening the nuts, slightly lift the engine and alternator assembly so that the weight is not
applied to the mount rubbers.
Fig. 10-26
Fig. 10-27
euqrotgninethgiT
m-N7.31-8.11
mc-gk041-021
bl-tf8.01-7.8
euqrotgninethgiT
m-N7.31-8.11
mc-gk041-021
bl-tf8.01-7.8
FRAME UPPER