Filter
Top Products
-1
i
Push the latchet-guide lightly by hand
so
that
the latchet guide won’t move and tighten the
set-screw.
(4)
Storing the spring-power.
-1
:Hold the case tight and using both hands,
wind
up
the reel counter-clockwise
6
times.
-2:
Set
the ree to keep the position, whereby the
rope hole
of
the reel and the rope guide make
a
direct line. (Fig.
9-7)
(3)
Tightening
the set-screw.
Fig.
9-7
WARNING
The spring power
is
at
its most when the
reel
is
being wound. Therefore,
do
not abruptly put
off
your
hand
nor
loosen
the
pressure
of
your finger unintentionally.
(5)
Setting the rope.
(2
persons required)
-1
:
Set the end
of
the rope through the
rope
guide and the rope hole
of
the reel and pull the end about
20
cm out
of
the reel. (Fig.
9-7)
-2
:
Fasten the end
of
the rope.
-3
:
Put the rope into the reel, whereby make sure
that the rope will not float up.
(Fig.
9-9)
-4:
Hold the rope firmly with one hand at the
position about
50
cm
from the rope guide
and
keep the rope slightly pulled
so
that the rope
will not be wound
in.
-5
:Put the hand
off
the reel gently and put the
rope back slowly obeying the winding power
of
the spring until the knob reaches the rope
guide.
Assembly is complete.
ABOUT
20mm
F;g.
9-8
Fig.
9-9
-
52
-