Filter
Top Products
9.
STARTING
SYSTEM
9-1
RECOIL
STARTER
Equipments to be prepared
:
Driver, Pinchers (Pliers) and Protective Glasses
WARNING
starting the disassembly;
make
sure to wear
the
protective glasses.
9-1-1
Disassembly
Steps
I
/
(1)
Setting off the spring power
-1
:
Hold
the starter knob and extract the starter
1
rope.
-2
:
Extract the rope fully and hold the rope
so
that the knob
of
the rope in the reel makes a
dicrect line with the rope guide.
-3
:Push
and hold the reel with the thumbs of
both hands firmly
so
that
the
rope will not be
wound back.
(Fig.
9-1)
-4:
Pull off the knot of the rope out
of
the reel,
unfasten the knot and pull it off to the direc-
tion
of
the starter knob.
(2
persons required)
-5
:
By
controling the reel with the thumbs
of
both
hands, unwind the rope gently until the rota-
tion
of
the
reel
stoos.
I
Fig.
9-1
r
The spring power is at its most when the rope is fully extracted. Therefore, do not abruptly put
off
your
hand nor loosen the pressure of your finger unintentionally.
(2)
Setting
the
attachments
off
(Fig.
9-2)
-
1
:
Fix
the case and loosen the set-screw.
-
2
:
Put off the set-screw, the latchet guide, the
friction
spring and the latchet in the same
order from above.
(3)
Setting the reel off (Fig.
9-2)
-
1
:Push
the reel lightly
so
that it
will
not float
up. Move the reel clockwise and counter-
clockwise about a quarter circle for several
times until it moves smoothly.
-
2
:
Pull up the reel gradually and slowly and put
it off from the case.
-
3
:
In
case the spring
in
the reel is close
to
pop
up,
redo the steps
of
(3)-1
and
(3)-2
again.
-
WARNING
Do
not drop or shake the reel and put
it
on
a level table
because there
is
a spring set in the disassembled reel.
Disassembly is complete.
-
50
e-
SET
SCREW
RATCHET
GUIDE
FRICTION
SPRING
RATCHET
'
REEL
Fig.
9-2