Filter
Top Products
(3)
Connect the speed control lever and the governor lever with the governor spring. The governor spring
’
(4)
Turn the speed control lever all the way toward the high speed position and make sure that the throttle
(5)
Turn the governor shaft clockwise all the way using a screw driver, and tighten the lock bolt and nut.
should be hooked to the number
2
hole on the speed control lever for the regular specifications.
Refer to the illustrations below. (See Fig.
5-42.)
valve
in
the carburetor is at the wide open position.
(See
Fig.
5-43.)
For the generator applications, there are two different governor springs existing according to the speed
setting of the engine. The governor springs may be distinguished
by
the following table.
The
governor spring employed on the
6OHz
application is same as the one from the standard specifi-
cations.
r
I
SPEED
CONTROL
LEVER
GOVERNOR
SPRING
\\
‘l)t--”
GOVERNOR
LEVER
Fig.
5-43
N
;
SPRING
WOUND
EH
1
2-2
EH25-2
EHl7-2
50
Hz
(3600
rpm)
(3000
rpm)
(3600
rpm)
(3000
rprn)
(3600
rpm)
(3000
rprn)
60
Hz
50
HZ
60
Hz
50
HZ
60
Hz
e
t
8.7
(0.34”)
9.6
(0.38”)
10.7
(0.42”)
8.1
(0.32”) 9.1
(0.35”)
D
t
43
(1
-73
t
38
(1.5‘7
t
49
(1.9’7
~
I
Color
Silver
Gold
Silver
Gold Silver Gold
~~~
-
41
-