Filter
Top Products
3.
Mounting
to
Engine
a)
Supply grease into the grease filler hole (the section shown with inclined lines in the figure) of the input shaft.
b) Set the packing in the coupling, and then clamp
it
to
the engine’s flywheel with
four
10
mm
x
30
9T
bolts.
Tightening torque:
550-700
kg-cm‘
c)
Apply grease to the coupling and spline gear teeth
of
the input shaft.
d) Set the
1/2
reducer in the engine under the condition that the spline teeth are engaged,
and
clamp it with four
8
mm
x
65
7T
bolts. Tightening torque:
200
-
230
kg-cm.”
r
FLYWHEEL
T
SHAFT
\
GREASE
FILLER
HOLE
COUPLING
Fig.
12-
70
-
54
-