Filter
Top Products
Se-
tuence
24
I_
25
Item
Connecting
rod
Bearing hous-
ing and crank-
shaft
Procedures
Remove the connecting rod
from the crankshaft.
From the crankshaft remove
the key on the side
of
fan.
Remove the bolt fastening the
bearing housing.
Pull
the crankshaft together
with the bearing housing.
(Gently tap the side of crank
gear with plastic hammer.)
Remarks
No
lock washer.
Be careful of the direc-
tion of rod. (Fan mark
is on the side of the
flywheel.)
Be careful
of
the setting
mark
of
the
cap.
(See Fig.
26.)
Be careful of the copper
shim
and
“0”
ring
be-
tween the bearing hous-
ing and the case.
Also
be careful
of
the
hole for
oil.
Bolts,
nuts etc.
used
8
x
22
7T
bolt.
.
.
6
pcs.
SW
. .
.6
pcs.
After pulling out the
crankshaft from the
case, remove housing.
The bearing remains on
the crankshaft.
(See Figs.
27,
28
and
29.)
Fig.
26
Fig.
27
Fig.
28
-18-