Filter
Top Products
Assemble the injection pump.
8
mm
nut
...............
3
pcs.
Spring washer
............
3
pcs.
NOTE:
Measure the distance between the face
of
the cam base and the surface to which the injection pump
is
to be
fitted. And adjust
it
may become
76
k
0.05
mm, using the shims. Two kinds of
the
shim are available,
viz.
0.1
mm, and
0.3
mm.
CAUTION:
Remove the
oil
filler cap and check
if
the control rack comes off from the governor lever.
(See Figs.
44
and
45
.)
-
.
.-
l._l
___
"I
~
."
,
,-
Fig.
45
Assembe the tappet guide.
CAUTION:
Be careful not
let
the tappet
fall
in
case.
NOTE:
The roll pin of the tappet guide
is
to
be
at
the right side
as
viewed from the gear case side.
(See
Fig.
46.)
the
set
Fig.
46
13)
Temporarily assemble the push rod sleeve.
6
mm
nut
...............
2
pcs.
Spring washer
............
2
pcs.
NOTE:
2
pcs.
of the plate (push rod
sleeve)
are to be assembled temporarily.
-
24
-