Filter
Top Products
FIGURE 26.
3.
Remove the engine pulley belt guard by slip.
ping it back and to the right. See figure 27.
FIGURE 24.
3. Unhook the deck belt from the engine. pulley.
4. Place the lift lever in the engaged (all the way
forward) position.
5. Disconnect the six deck links by removing the
hairpin cotters and flat washers.
6. Slide the deck from beneath the lawn tractor.
7. Remove the belt guards at each deck pulley by
removing the hex bolts, lock washers and hex
nuts. See figure 25.
8. Remove and replace the belt, following the in-
structions in reverse order.
u
..."
Pulleys ,.f
,f"
~ .
~ .
Bolts
Lock Washers
Hex Nuts,
,;/
FIGURE 27.
~
11M""",,
f.
4.
Remove the bolt, lock washer and nut which
hold the idler pulley to the idler bracket. See
figure 28.
;)7
FIGURE 25.
Removing the Drive Belt
1. Follow steps 1 through 3 on removing the
deck belt.
2. Remove the two bolts, lock washers and nuts
on each side of the frame which hold the
engine pulley belt guard to the frame. See
figure 26.
NOTE
Upon reassembly, the hub side of
the idler pulley must be assembled
against the idler bracket.
16