Filter
Top Products
36
Section 4: Options & Accessories
RC4015 and RCM4015 Series 2 S/N 944961+ Rotary Cutters 330-845M
10/21/15
Table of Contents
Light Kit Option (LED)
331-498A Folding Cutter Light Kit 2.5"
Refer to Figure 4-4:
The lead wiring harness (#20) is equipped with a 7-way
round pin connector. Make sure your tractor is equipped
with the 7-pin electrical outlet shown in Detail C before
purchasing this product.
1. Lower cutter center deck and wing decks down until
unit is resting on the lift cylinder stops and both wings
are on the ground.
2. Shut tractor down properly before dismounting. Refer
to “Tractor Shutdown Procedure” on page 13.
3. Move hydraulic control lever back and forth several
times to release all hydraulic pressure in hydraulic
lines to the cutter.
4. On the right-hand wing, remove cotter pin (#10), flat
washers (#8), transport bar (#1), and clevis pin (#11).
5. If not done, thread connector (#1A) through
hole (#21) as shown in Detail A.
6. Attach right-hand light assembly (#3) under hydraulic
cylinder (#13) with mounting clamp (#2) on top.
NOTE: Hydraulic hoses (#15 & #16) must be
located above mounting clamps (#2) as shown.
NOTE: Amber lights are located to the outside and
red lights are located to the inside as shown.
7. Nuts (#7) must be on top. Secure unit to cylinder
with 3/8"-16 x 4" GR5 bolts (#6) and lock nuts (#7).
Draw lock nuts up snug, do not tighten at this time.
8. Slide light assembly (#3) and mounting clamp (#2) as
far as possible toward the rod end of hydraulic
cylinder (#13).
9. Tighten each lock nut (#7) one-half turn in a criss-
cross pattern until all nuts are torqued tight.
10. Replace clevis pin (#11), flat washers (#8), transport
bar (#1), and cotter pin (#10), Bend one or more legs
of cotter pin to keep pin (#11) from falling out.
11. Repeat steps 4 thru 10 for the left-hand light
assembly (#4).
NOTE: Right-hand wire harness (#17) has a red
wire showing at both ends. Left-hand harness (#18)
has a yellow wire showing at both ends.
NOTE: See Detail B: Pins in the connectors are
labeled A, B, C, & D. Match yellow and red wires
with same pin letters when attaching wire harness to
light assemblies (#3 & #4) & enhance module (#19).
NOTE: Route wire harnesses (#17, #18, & #20)
alongside hydraulic hoses. Make sure harnesses
will not become pinched as the deck is raised and
lowered and wings are folded up and down.
Light Kit (Shown on RC3615 Deck)
Figure 4-4
Detail B
Detail C
Detail A