Land Pride RCM4015 Brush Cutter User Manual


 
25
Section 2: Adjustments
10/21/15
RC4015 and RCM4015 Series 2 S/N 944961+ Rotary Cutters 330-845M
Table of Contents
7. Be sure both sides are equal distance from ground to
continuous hinges and that left and right leveling rods
have equal tension. Re-tighten jam nut (#3).
Wing Deck Leveling
Refer to Figure 2-4:
Each wing section will need adjusting if wing top is not
level with center deck top when wings are unfolded.
1. With tractor hydraulics, lower wings down. Refer to
“Field Set-up” on page 31 for instructions on how to
lower wings.
2. Pull cutter straight forward six to ten feet to allow
outer wing wheels to properly align themselves.
3. Check wing tops to see if they are level with the top of
the center deck. If the outer edge of either wing top is
higher or lower than the center deck, then that wing
should be leveled as follows:
a. If outer wing edge is higher than the center
deck, loosen jam nut (#1) & rotate turnbuckle (#2)
clockwise to lower outer wing edge until wing is
level. Tighten jam nut (#1) to the correct torque
when level.
b. If outer wing edge is lower than the center deck,
loosen jam nut (#1) and rotate turnbuckle (#2)
counterclockwise to raise outer wing edge until
wing is level. Tighten jam nut (#1) to the correct
torque when level.
Leveling Wing Decks
Figure 2-4
27926
1
2
Clockwise Rotation Shown
Center Deck Leveling
Figure 2-3
J
am
27857
1
Right-hand Leveling Rod
Left-hand Leveling Rod
Stroke Control
Spacers
J
a
m
3
4
3
4