Land Pride RCM4015 Brush Cutter User Manual


 
18
Section 1: Assembly & Set-up
RC4015 and RCM4015 Series 2 S/N 944961+ Rotary Cutters 330-845M
10/21/15
Table of Contents
Transport Bar, Locked Position
Figure 1-17
Lower Wings
!
DANGER
Keep everyone out of the area where the wing decks will
unfold into. A wing that falls suddenly on a person will cause
serious bodily injury or death.
Refer to Figure 1-17:
1. Park tractor and cutter on a level surface.
2. Raise both wings up to release any tension on
transport lock bars (#3).
3. Shut tractor down properly before dismounting. Refer
to “Tractor Shutdown Procedure” on page 13.
4. Remove hairpin clip (#1) from both the left and right
cylinder pins (#4).
Refer to Figure 1-18:
5. Rotate end of transport lock bars (#3) to storage
pins (#2) on both left and right wings.
6. Secure with hairpin clips (#1).
7. Restart tractor and lower both left and right wings
with tractor hydraulic control lever until both wings
are on the ground.
1
4
3
27921
Transport Bar, Storage Position
Figure 1-18
Driveline Installation
!
DANGER
Do not engage tractor PTO while hooking-up and unhooking
driveline or while someone is standing near the driveline. A
person’s body and/or clothing can become entangled in the
driveline resulting in serious injury or death.
!
WARNING
Always disengage PTO, place tractor in park or set park
brake, shut tractor engine off, remove switch key, and wait for
blades to stop before dismounting from tractor.
!
WARNING
Do not operate cutter above its rated PTO speed or machine
breakage may result.
!
WARNING
Make certain all driveline yokes are securely fastened at both
ends. A loose yoke can work free allowing the driveline to
rotate uncontrollably causing machine damage and bodily
injury or death to anyone nearby.
27923
3
2
1
4
IMPORTANT: Do not attempt to operate a 540 rpm
driveline at 1,000 rpm or a 1,000 rpm driveline at 540
rpm. Many tractors provide both 540 and 1,000 rpm
PTO modes. Check your tractor’s manual to
determine its capabilities.