Filter
Top Products
25
Section 3: Adjustments
2-16/09
OS1548 and OS1572 Overseeder (S/N 166724+) 308-303M
Land Pride
Table of Contents
Rear Roller Drive With Front Roller
Cutting Depth Adjustment
Refer to Figure 3-7:
1. Adjust turnbuckles on the front roller as necessary by
loosening jam nuts (#3) and turning turnbuckles (#4)
to get proper cutting depth.
2. Retighten jam nuts making sure dimension (B) is
equal on both sides.
Refer to Figure 3-8:
3. Level Overseeder from front to rear by loosening jam
nuts (#1) and adjusting rear roller turnbuckles (#2).
4. Retighten jam nuts making sure dimension (A) is
equal on both sides.
5. Recheck knife depth to make sure no additional
adjustments are needed to the front roller and rear
roller turnbuckles.
Floating Top Link Adjustment
Refer to Figure 3-8:
Floating top link is used only when the seeder set-up is
rear roller drive with front roller support.
Refer to Figure 3-9:
Set floating top link 16" from center line of top center link
hitch hole to center line of lower lift arm hitch holes by
adjusting length of tractor’s top center link.
IMPORTANT: With this option, the cutting depth of
the knives is set by the front roller. The lower arms on
the tractor’s 3-point hitch should be in float position.
Front Roller Turnbuckle
Figure 3-7
Rear Roller Drive w/Front Roller
Figure 3-8
Floating Top Link
Figure 3-9
11146
11663
11590
Floating Top Link