Filter
Top Products
11
Section 1: Assembly & Set-up
2-16/09
OS1548 and OS1572 Overseeder (S/N 166724+) 308-303M
Land Pride
Table of Contents
15. Torque all bolts to the proper specifications, see Torque
Values Chart in the “Appendix” starting on Page 48.
Tighten bolts in the following order:
a. Rotor to rotor drive hub.
b. Bearing mount plate to Overseeder main frame.
c. Bearing cover thru bearing mount plate to bearing mount.
16. Position hub inside bearing mount against bearing seal and
tighten set screws.
17. Add grease to right hand bearing by using grease zerk
located on the right hand bearing cover.
18. Reassemble gauge wheel & drive chains. Reattach chain
guard.
Rear Roller Assembly
Refer to Figure 1-6:
1. Attach packer wheel assembly (#1) to back of Overseeder
frame using 1” x 3 11/16” long clevis pins (#2), 1” flat
washers (#3) and 3/16” x 1 3/4” long cotter pins (#4). If your
Overseeder has a rear roller drive, see Rear Roller Drive
below and skip step 2.
2. Attach support chains (#5) to back of frame and to packer
wheel arms using 5/16” utility clevises (#6).
Gauge Wheel Drive
Refer to Figure 1-7:
1. Bolt drive spindle and hub assembly (#1) to the right hand
gauge wheel arm (#2) using 5/16” x 1 1/2” long bolts (#3) and
5/16” lock nuts (#4).
2. Install wheel assembly (#5) to right hand wheel hub with 1/2”
x 1 3/8” long lug bolts (#6) and 1/2” lug nuts (#7). Follow the
same steps for the left hand side, except use non-drive
spindle and hub assembly (#8) and bolts (#6).
3. Bolt chain guard (#9) to the right hand frame end plate using
1/4” x 1/2” long bolts (#10).
Rear Roller Drive
Refer to Figure 1-8:
1. Attach solid links (#1) to back of frame with 5/8” x 2 3/4” long
bolts (#2) on top and 5/8” x 1 3/4” bolts (#4) on the bottom.
2. Bolt chain guard (#9) to end plate using 5/16” x 6” bolt (#10),
5/16” lock washer (#11) and 1/4” x 1/2” bolts (#12).
3. If rear roller (#13) is in the short arm position as shown,
attach front chain guard (#7) and rear chain guard (#6) with
5/16” x 2 1/2” bolts (#8) in the locations shown.
IMPORTANT: Roller chains must be installed on the
seeder at the correct gear ratio. Refer to Seeding
Adjustments in the “Adjustments” section starting
on Page 18 to determine correct chain installation.
IMPORTANT: Roller chains must be installed on the
seeder at the correct gear ratio. Refer to Seeding
Adjustments in the “Adjustments” section starting
on Page 18 to determine correct chain installation.
Rear Roller Installation
Figure 1-6
Gauge Wheel Drive Assembly
Figure 1-7
Rear Roller Drive Assembly with Short Arm
Figure 1-8
14599
14598
14601