Filter
Top Products
ASSEMBLY
OM 0408SB1174-A
16
Installation of Snowblower with Quick Hitch
(Figure 5)
CATEGORY 1 only
1. Install the two cat.1 pins (item 2) on the right
and left snowblower hitches in the upper
holes leaving 3 1/4" between the jam nut and
the end of the pin as shown on figure.
2. Insert the two 2 1/8" lg bushings (item 3) on
each pin and lock in place with the two 7/16"
linchpins (item 4).
3. Insert the 1 7/8" lg bushing (item 5) between
the upper attaching plates and lock in place
with the tractor hitch pin and a 7/16" linchpin
(items 6-7).
4. Install the eyebolt (item 8) in the upper hole of
the left or right side of the three point hitch by
screwing the eyebolt nut to the top and
locking eyebolt in place with a 3/8" serrated
flange nut (item 9).
Before connecting snowblower driveline to
tractor drive shaft, make sure driveline is
not too long in raised, lowered and middle
position. If the driveline is too long it must
be shortened, to avoid damaged to tractor.
See pages pages 27 to 29 for instructions.
CAUTION
Figure 5