Filter
Top Products
ASSEMBLY
OM 0408SB1174-A
13
TRACTOR PREPARATION
See Dealer for Tractor Preparation information.
SNOWBLOWER ASSEMBLY
The snowblower is assembled at the factory except for the parts in the hardware bag provided with the
snowblower, the chute and the options if appropriate. Use the present manual and lay out all parts for
assembly. Separate bolts and nuts into various sizes. After assembly, torque all the bolts according to the
Torque Specification Table at the end of manual.
Installation of SMV Sign
(Figures 1-2)
1. Figure 1: Remove the 1/4" NC x 1 1/4", the
flat washer, the lockwasher and the nut
(items 1-2-3-5) that fixes the sign (item 4) to
the frame. Save the hardware.
2. Figure 2: Install the sign support (item 1) on
the snowblower with two 1/4" NC x 1" bolts,
two 1/4" flat washers and two 1/4" NC nylon
insert nuts (items 2-3-4).
3. Figure 2: Using the hardware previously
removed, attach the SMV sign (item 5) with,
a 1/4" NC x 1" bolt (item 6), a 1/4" NC x 1
1/4" bolt (item 7), two flat washers (item 8),
a 1/4" nylon insert nut (item 9), a 1/4"
lockwasher (item 10) and a 1/4" hex nut
(item 11).
4. Remove the black protective film from the
SMV sign.
Figure 2
Figure 1