John Deere AC-G6000DY Portable Generator User Manual


 
Preparing the Generator
16 Operator’s Manual
2. Free water in FAME may result in plugging of fuel lters
and increased bacterial growth.
3. High viscosity at low temperatures may result in fuel
delivery problems, injection pump seizures, and poor
injection nozzle spray atomization.
4. FAME may have adverse effect on some elastomers (seal
materials) and may result in fuel leakage and dilution of
the engine lubricating oil.
5. Even bio-diesel fuels that comply with a suitable standard
as delivered, will require additional care and attention to
maintain the quality of the fuel in the equipment or other
fuel tanks. It is important to maintain a supply of clean,
fresh fuel. Regular ushing of the fuel system, and/or
fuel storage containers, may be necessary.
6. The use of bio-diesel fuels that do not comply with
the standards as agreed to by the diesel engine
manufacturers and the diesel fuel injection equipment
manufacturers, or bio-diesel fuels that have degraded
as per the precautions and concerns above may affect
the warranty coverage of your engine.
BATTERY INSTALLATION
WARNING: SHOULD ONLY BE DONE BY AN
AUTHORIZED DEALER.
HIGH ALTITUDE
Observe the following environmental operating conditions
to maintain engine performance and avoid premature
engine wear:
• Never run the engine if the ambient temperature is
above +104ºF (+40ºC) or below +14ºF (-10ºC).
• If the ambient temperature exceeds +104ºF (+40ºC)
the engine may overheat and cause the engine oil to
break down.
• If the ambient temperature falls below +14ºF (-
10ºC) rubber components such as gaskets and
seals will harden causing premature engine wear
and damage.
• Contact your authorized Yanmar industrial engine
dealer or distributor if the engine will be operated in
either temperature extreme.
• Contact your authorized Yanmar industrial engine
dealer or distributor if you need to operate the en
gine at high altitudes. At high altitudes the engine
will lose power, run rough, and produce exhaust
gases that exceed the design specications.
BATTERY REPLACEMENT #
32-0058