Filter
Top Products
Page 83
J-400
8. Adjusting Fader Level
Press EQ button (5) repeatedly until display reads “FADER.” Press
VOL Up/Down button (3) to choose desired setting. A display of
“FADER F-R” indicates center, R01 to 15 indicates rear fade, F01 to
15 indicates front fade.
Note: Unit returns to volume mode if volume control is not operated for 3
seconds.
9.
Press and hold down EQ button (5) for about 2 seconds until display
reads “BEEP 2ND”, then release. Press VOL Up/Down button (3) to
select either BEEP 2ND or BEEP on option.
Select BEEP on, you can hear “beep” sound when you press all •
buttons.
Select BEEP 2ND, you can hear “beep” sound when you press the •
button over 1.5 secs.
Note: Unit returns to volume mode if volume control is not operated for 3
seconds.
10. Adjusting I-VOL Level
Press and hold the EQ button (5) for about 2 seconds, then
repeatedly press until display reads “I-VOL” (Initial Volume Level
Adjustment). Press VOL Up/Down button (3) to choose desired set-
ting (0 to 45), and the I-VOL will be set automatically. This feature
regulates the max volume level during power up. If the volume level
is higher than the initial volume setting when audio unit is turned off,
once the audio unit is switched back on again, the audio unit will
keep the volume adjusted to the preset level. If the volume level is
lower than the initial volume setting when audio unit is turned off, it
will remember the lower level and resume volume at that level when
unit is turned on again.
Note: Unit returns to volume mode if volume control is not operated for 3
seconds.
11. Adjusting Area
In Radio mode, press and hold the EQ button (5) for about 2
seconds, then repeatedly press until display reads “AREA USA” or
“AREA EUR”. Press VOL Up/Down button (3) to choose desired
setting, then press and hold the BND button (8) for 2 seconds to
conrm selection.
Note: Unit returns to volume mode if volume control is not operated for 3
seconds.