Filter
Top Products
Page 76
J-400
14. Audio Communication Malfunction: Communication between the
control panel and audio system is faulty. Shutdown power to the
spa, wait 3 seconds and restart the spa to reset the communication.
Contact your authorized dealer or service organization.
15. Blinking Heater icon: This icon will blink on and off to indicate that:
• The temperature sensor is sensing a -20°F/6°C
difference between the actual and set temperature or;
• The temperature sensor is sensing a temperature above
112°F/44°C or the hi-limit temperature sensor is sensing
a temperature above 116°F/46°C.
16. Extended Temperature
Activated:
The spa is set to go up to
104°F (40°C), but it can
be set to reach 106°F
(41°C). To access the
extended temperature you must press the “Up” (on the
Quad Keypad) button and the button D at the same time for 2
seconds. The system will now allow you to raise the temperature to
106°F (41°C) and the LCD display will read “EXTENDED
(Figure A). To clear this message,
just press the Down button on the Quad Keypad to lower the
temperature below or back to 104°F (40°C).
17. Please Check Filter!
This message will appear when the lter
reminder time has expired (Figure B).
Please remove the Proclear lters and
lter bag for cleaning or replacement.
18. Feature not installed: (Exterior lights)
This message will appear when a
user tries to activate the exterior
lights and they are not installed
(Figure C). To clear the message
press button D to return to Main
Menu.
106
F
Temp.
6:45 PM
Extended Temperature
Activated
UP
C
B
A
D
Figure A
102
F
Temp.
6:45 PM
Please check filter!
Figure B
EXTERIOR
Feature not installed
C
B
A
D
Figure C