Filter
Top Products
English – 25
STARTING AND STOPPING
CAUTION!
The first time the sawmill is started or
when it has been moved to another
power outlet:
• Test start the sawmill in accordance
with the starting instructions.
• Check the direction of the bandsaw
blade. If the bandsaw blade runs in
the wrong direction, there is a phase
inverter on the power connector
(FIG. 42). The phase is inverted with
the aid of a screwdriver, as illus-
trated in FIG. 42.
WARNING!
The sawmill must not be
started until the appropriate
current and voltage has been
connected. Use suitable per-
sonnel trained in the country in
question.
Starting the Electric Sawmill
FIG. 42
FIG. 43
!
Starting the Electric Motor
1. Check that the power cable is connected
correctly.
2. Set the main switch (35) to 1.
3. Start the motor with the green start button
(33). The motor starts.
Stopping the Electric Motor
1. The electric motor is stopped with the raised
red button (32).
2. Set the main switch (35) to 0.
Starting and Stopping the
Bandsaw Blade
The blade is started and stopped using the
control handle (4) on the sawmill’s handlebars
(5). Moving the starter handle towards the
handlebars activates the clutch and the bandsaw
starts. When the control handle is released, the
bandsaw blade is braked and stops.
FIG. 44