Filter
Top Products
English – 19
Maintenance
Cleaning
Clean the machine directly after use. It is much easier to wash
off grass cuttings before they dry.
Oily dirt can be removed using a cold degreasing agent.
Spray on a thin layer.
Rinse at normal water pressure.
Do not direct the jet towards electrical components or
bearings.
Do not rinse hot surfaces such as the engine and exhaust
system.
Hose down the cutting unit with water underneath each time
it is used.
It is recommended that you start the engine and run the
mower for a short period after cleaning, so that any remaining
water is blown off.
Lubricate the machine if necessary after cleaning. Carry out
extra lubrication when the bearings have been exposed to a
degreaser or a water jet.
There is a major risk of water penetrating into bearings and
electrical connections. Corrosion attack can result, which will
lead to running problems. Cleaning additives generally
aggravate the damage.
Removing of the machine hoods
Engine cover
The engine becomes accessible for service when the engine
cover is opened.
Loosen the snap locks (one on each side) and fold the cover
backwards.
To remove the rear cover completely, pull it back sharply when
in raised position.
Front cover
Release the clip on the right side of the mower deck and lift
the cover off the mower deck.
Right-hand fender
Remove the screws and the back pedal knob, and lift off the
cover.
Left-hand fender
Loosen the screws holding the wing cover and lift off the
cover.
IMPORTANT! Avoid using a high pressure washer or a
steam cleaner.