Husqvarna 343R, 345RX, 343F, 345FX, 345FXT Brush Cutter User Manual


 
5
1
!
Starter
Assembly
Clean requisite parts and assemble in
the reverse order as set out for disman-
tling.
Assembly
Clean all components before assembly:
Change return springs, starter pulley
and starter cord as needed.
NOTE!
Be careful when opening the packaging with the return spring so that the
spring does not fly out.
Attach the spring cassette.
Attach the starter pulley.
Attach the new starter cord.
Attach the spring cassette and tighten
the two bolts (A).
Lubricate the bearing journal with a little
grease and attach the starter pulley.
Place the washer in place and tighten
the bolt.
Attach the new starter cord. Push it in to
the starter pulley’s track as illustrated and
then out through the cord guide in the
starter cover. Make sure that the knot at
the end of the cord is as small as possible!
NOTE!
New starter cords can be attached without dismantling the starter!
Anchor the cord in the starter handle. Thread the cord through the starter
handle and anchor it with a knot.
Fold down the free end and pull the
knot well into the handle.
Remove the spring cassette.
Remove the two bolts holding the
spring cassette and remove the
cassette for replacement if necessary.
WARNING!
Wear protective glasses. The return spring can fly out
and cause personal injury if improperly handled.