Husqvarna 343R, 345RX, 343F, 345FX, 345FXT Brush Cutter User Manual


 
28
3
G
Fuel system
Remove the bolt (A) and remove the
throttle from the handle.
Remove bolts (B) and (C).
Separate the halves of the throttle.
Remove the bolt (A) that attaches the
throttle to the handle.
Be careful not to lose the nut.
Remove the throttle and remove bolts
(B) and (C).
Carefully separate the two halves of the
throttle.
Check for wear on pins (A) and (B).
Replace the throttle control (C) and
lever arm (D) if necessary.
Check that the cables are properly
pressed into the cut-outs (E) and that
the throttle cable (F) is in the right
groove.
If necessary, attach it with silicon
adhesive in order to facilitate assembly.
Check that the protective bellows (G)
are whole and that they are correctly
mounted over the ball on the cable.