Filter
Top Products
English - 57
9. TROUBLE SHOOTING
No drive R40Li has got caught in something. Free the mower and rectify the
reason for the lack of drive. If it is due
to wet grass, wait until the lawn has
dried before using the mower.
The working area includes a steep
slope.
Maximum guaranteed slope is 25%.
Steeper slopes should be isolated.
See 3.4 Installation of the boundary
wire on page 20.
The guide wire is not laid at an angle
on a slope.
If the guide wire is laid on a slope, it
must be laid at an angle across the
slope. See 3.6 Installation of the
guide wire on page 27.
Charging station
blocked
The contact between the charging
strips and contact strips may be poor
and R40Li has made a number of
charging attempts.
Place R40Li in the charging station
and check that the charging strips
and contact strips make good
contact.
An object is obstructing R40Li. Remove the object.
Stuck in charging
station
There is an object in the way of R40Li
preventing it from leaving the
charging station.
Remove the object.
Upside down R40Li leans too much or has turned
over.
Turn the mower the right way up.
Needs manual
charging
R40Li is set in MAN operating mode. Park the mower in the charging
station. This behaviour is normal; no
action required.
Next start hh:mm The timer setting prevents the mower
from operating.
Change the timer settings. See 6.3
Timer (1) on page 41.
The daily standby period for the
battery is underway. The mower has
to be in the charging station for at
least 11 hours a day.
This behaviour is normal and no
action is required.
Message Cause Action