Filter
Top Products
English - 53
8. MAINTENANCE
8.4 Transport and removal
Secure the machine during transport. It is important
that R40Li does not move when it is being transported,
for instance, between lawns.
8.5 In the case of thunderstorms
To reduce the risk of damage to components in the
R40Li, we recommend that all connections to the
charging station are disconnected (power supply,
boundary wire and guide wire) if there is a risk of a
thunderstorm.
8.6 Replacing the blades
There are three blades on R40Li, which are screwed
into the blade disc. All three blades and screws must
be replaced at the same time to obtain a balanced
mowing system.
Use GARDENA approved blades only.
To replace the blades:
1. Set the main switch to the 0 position.
2. Wear protective gloves.
3. Turn R40Li upside down.
4. Remove the screw. Use a straight slot or
cross-tip screwdriver.
5. Remove the blade and the screw.
6. Screw on the new blade and the new screw.
WARNING
Always use originalblades and
screws when replacing.
Only replacing the blades and
reusing the screw can result in the
screw wearing during mowing and
shearing off. The blades can then be
thrown out and cause serious injury.