Filter
Top Products
English - 19
3. INSTALLATION
Installation and connecting the charging
station
1. Position the charging station in a suitable spot.
2. Connect the low voltage cable to the charging
station.
3. Connect the transformer’s power cable to a 230V
wall socket. If the transformer is connected to
wall socket outdoors, it must be approved for
outdoor use.
4. Attach the charging station to the ground using
the supplied screws. Ensure the screws are
screwed all the way down in the countersink.
3.3 Charging the battery
As soon as the charging station is connected, it is
possible to charge the mower.
The mower can be charged as soon as the charging
station is connected. Set the main switch to the
1
position.
Place R40Li in the charging station to charge the
battery while the boundary and guide wires are being
laid.
If the battery is flat, it takes around 80 to 100 minutes
to fully charge it.
IMPORTANT INFORMATION
It is not permitted to make new holes in the
plate. Only the existing holes may be used to
secure the plate to the ground.
IMPORTANT INFORMATION
Do not tread or walk on the charging station
plate.
IMPORTANT INFORMATION
R40Li cannot be used before the installation
is complete.