Filter
Top Products
English - 35
4. USE
4.3 Starting
1. Set the main switch to the 1 position.
2. Press the STOP button to open the control panel
cover.
3. Enter the PIN code.
4. Push the Start button.
5. Shut the cover within 10 seconds.
If the mower is parked in the charging station, it will
only leave the charging station when the battery is
fully charged and if the timer is set to allow the mower
to operate.
Before the blade disc starts, 5 beeps are heard for 2
seconds.
4.4 Stopping
1. Press the STOP button.
R40Li stops, the blade motor stops and the
control panel cover opens.
4.5 Switching off
1. Press the STOP button.
2. Set the main switch to the 0 position.
Always switch R40Li off using the main switch if it
requires maintenance or if the mower must be moved
outside the working area.
4.6 Adjusting the cutting height
The cutting height can be varied from MIN (2 cm) to
MAX (5 cm).
To adjust the cutting height:
1. Press the STOP button to stop the mower and
open the cover.
2. Turn the height adjustment knob to the required
position. The selected position is indicated by the
orange column that can be seen by the knob
through the window.
• Turn anti-clockwise to raise the cutting height.
• Turn clockwise to lower the cutting height.
IMPORTANT INFORMATION
During the first week after a new installation,
the cutting height must be set to MAX to
avoid damaging the loop wire. After this, the
cutting height can be lowered step by step
every second week until the desired cutting
height has been reached.
Start
1
4
78
0
9
56
23
Start
1
12345
4
78
0
9
56
23