Filter
Top Products
7
DOWNROD
HAIRPIN
CLIP
CLEVIS PIN
SETSCREW
CLEVIS PIN
MOTOR
COUPLING
DOWNROD
HAIRPIN
CLIP
MOTOR
COUPLING
Figure 12
It is critical that the clevis pin in the motor coupling
is properly installed and the setscrew securely
tightened. Failure to verify that the pin and setscrew
are properly installed could result in the fan falling.
WARNING
23. Install the setscrew (supplied) in the motor
coupling and tighten using the 5/32” setscrew
wrench (supplied) (Figure 13).
24. Screw two 1-1/4” threaded studs (supplied) into
the motor (Figure 14). Leave approximately 7/8”
of the stud extending above the motor. Coil the
wires and wire connectors around the motor
coupling.
DOWNROD
SETSCREW
CLEVIS PIN
MOTOR
COUPLING
DOWNROD
HAIRPIN
CLIP
5/32" SETSCREW
WRENCH
Figure 13
DOWNROD
MOTOR
COUPLING
7/8"
Figure 14
KNURLED KNOB
(1 PER STUD)
DOWNROD
LOCKWASHER
(1 PER STUD)
THREADED STUD
MOTOR COVER
Figure 15
SETSCREW
HANGER
BALL
DOWNROD
PIN
CEILING
COVER
Figure 16
25. Slide the motor cover over the downrod and
rotate the cover until the threaded studs protrude.
Install one lockwasher (supplied) and one knurled
knob (supplied) onto each threaded stud to
secure the cover to the motor. All wires and wire
connectors must be enclosed under the motor
cover (Figure15).
NOTE: Lightly snug the knurled knob and make
sure the wires and wire connectors are completely
inside the motor coupling cover and not pinched
between the motor coupling cover and the motor.
IMPORTANT
A. If you have installed the 12” or optional longer
downrod and are planning to install the
decorative scroll assembly, proceed to
“Installation of the Decorative Scroll
Assembly” on page 8. After you have installed
the decorative support rods assembly,
continue with the following installation
procedures.
B. If you have installed the 6” downrod, continue
now with the following procedures.
26. Position the ceiling cover over the downrod. Be
sure the cover is oriented correctly, with the large
opening at the top (Figure 16).
27. Reinstall the hanger ball on the downrod
as follows. Route the motor leads through the
hanger ball and slide the hanger ball over the
downrod (Figure 16). Install the pin through the
holes at the top of the downrod and slide the
hanger ball up the downrod, aligning the ball so
the pin is captured in the groove in the top of the
hanger ball. Pull the hanger ball up tight against
the pin and securely tighten the setscrew in the
hanger ball. A loose setscrew could create fan
wobble.
U.L. Model No.: CF3200