Filter
Top Products
Operating Your
Ceiling Fan
IMPORTANT
Fan installation must be completed, including the
installation of the fan blades, before testing of the
remote control.
NOTE: The downlight button will not work unless
an Emerson light kit is added to the ceiling fan.
Your SW116 Fan/Light Wall Control (Figure 30) has
full control of your fan, lights, and airflow direction.
1. To set the desired fan speed, push the HI, MED, or
LOW buttons to operate your fan on high, medium
or low speed (See Figure 30).
2. To reverse the direction the fan is turning, press
the REV button. The direction the fan turns will
change each time the REV button is pressed.
3. To turn your fan off, press the FAN OFF button.
4. To set the level of light brightness, press and hold
the U/L (uplight) button or the D/L (downlight)
button (if downlight kit is added to fan). The light
brightness will continue to increase then decrease
while the button is held down. When the light is at
the desired brightness, release the button.
AIRFLOW
DIRECTION
BUTTON
LIGHT
BUTTON
FAN
SPEED
BUTTONS
FAN OFF
BUTTON
RED
INDICATOR
LIGHT
FAN OFF
LOW
MED
HI
D/L
U/L
LIGHT
REV
Figure 30
5. To turn the lights on and off, press and release the
U/L (uplight) button or the D/L (downlight) button (if
downlight kit is added to fan). The lights will turn on
at the light level previously set (see Step 4).
Red light turns on when any button is pressed.
If the light does not come on, replace your battery.
INSTRUCTION TO THE USER (if device contains a digital device)
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and if no installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is not guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This equipment has been certified to comply with the limits for a class B computing device, pursuant to FCC
Rules. In order to maintain compliance with FCC regulations, shielded cables must be used with this
equipment. Operation with non-approved equipment or unshielded cables is likely to result in interference to
radio and TV reception. The user is cautioned that changes and modifications made to the equipment without
the approval of manufacturer could void the user’s authority to operate this equipment.
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment
Regulations.
12
U.L. Model No.: CF3200