Filter
Top Products
OPERATION
TOENGAGETHEWHEELS
CAUTION
. To avoid damaging the
transmission, do not shift
gears while in motion.
• To avoid damaging the
wheel brake mechanism, do
not engage the Wheel Drive
Controlwithout first engaging
the Operator Presence
Control.
WARNING
Before engaging the Wheel
Drive Lever for the very first
time, check that the neutral
(N) position on the Gear Se-
lect Lever is properly adjust-
ed. See "Neutral Adjust-
ment" in "Service and
Adjustments" Section for the
procedureto follow.
Failure to follow this instruc-
tion could result in personal
injury or propertydamage.
1. Start engine as described in
"To Start the Engine" instructions.
2. FOR FORWARD TRAVEL:
A. Press and hold Operator Pres-
ence Control (A, Figure 3-13)
against handlebar grip.
B. Put the Gear Select Lever (C,
Figure 3-13) into one of the
numbered settings (1 - Slow, 2 -
Medium and 3 - Fast). When
first practicing with the mower,
put lever in No. 1 setting. Se-
lect forward speeds according
to mowing conditions and ter-
rain. Use slower speeds on
rough terrain or when grass is
heavy or thick. The forward
speed can be increased on
smooth terrain or if the grass
cover is light. Allow the wheels
to step completely before shift-
ing from one forward speed into
: another.
C. To start the wheels, slowly
squeeze the Wheel Drive Con-
trol (D, Figure 3-13). The hard-
er you squeeze, the faster the
wheels willturn. To avoid sud-
den acceleration, slowly
squeeze the lever.
D. TO STOP THE WHEELS:
• To stop drive power to the
wheels, release the Wheel
Drive Control. The wheels will
gradually slow to a stop.
• To quickly stop the wheels, re-
lease both the Wheel Drive
Control and the Operator Pres-
ence Control.
WARNING
To avoid injury or property
damage:
• Look behindmower before
andduringreverseoperation.
• Stopthe mower blades be-
foreoperatingin reverse.
3. FOR REVERSE TRAVEL:
A. Stop the mower blades and
wheels by releasing the Opera-
tor Presence Control (A, Figure
3-13).
B. Press and hold Operator Pres-
ence Control against handlebar
grip.
CoPut the Gear Select Lever (C,
Figure 3-13) in R (reverse) set-
ting by first moving lever to N
(neutral). Then pull lever up,
turn it to R position, and release
leve_
D. To start the wheels, slowly:
squeeze Wheel Drive Control
(D, Figure 3-13). To avoid sud-
den acceleration, slowly
squeeze the lever.
E. TO STOP THE WHEELS:
• To stop drive power to the
wheels, release the Wheel
Drive Control. The wheels will
gradually slow to a stop.
• To quickly stop the wheels, re-
lease both the Wheel Drive
Control and the Operator Pres-
ence Control.
• Return the Gear Select Lever
to the N (neutral) position when
you have completed reverse op-
eration. Allow the wheels to
stop completely before shifting
from R (reverse) into a forward
speed.
MAKINGTURNS
The mower turns easily by push-
ing the handlebars in the opposite
direction that you want to turn. The
differential mechanism inside the
transaxle will allow the inside turn-
ing wheel to stop or slow down
while the outside turning wheel is
powered by the drive system.
Reduce the wheel speed before
turning the mower. For tight turns,
disengage the Wheel Drive Control
and manually push the mo_,er
through the turn (if needed, put the
Gear Select Lever in neutral so the
wheels turn freely).
2O