Filter
Top Products
ASSEMBLY
I
I
I
!
I
I
I
I
I
I
I
I
I
!
!
I
!
I
I
!
I
P
Figure 2-7: Detail- TransmissionNeutralAdjustment.
• Insert hooked end of shift link (P,
Figure 2-7) into hole in bottom end
of gear select lever (I) and secure
with cotter pin (Q). Bend ends of
cotter pin. NOTE: It may be nec-
essary to lift gear select lever (I) to
install shift link (P).
* Hold down Operator Presence
Control lever (W, Figure 2-5) and
push unit forward and backward.
The wheels should move freely. If
not, adjust length of shift link (P,
Figure 2-7) as necessary.
E. TestWheel Brake:
Put the Gear Select Lever in in
neutral (N), release all of the con-
trol levers, and try to push the unit
forward and backward. The
wheels should not turn. if they do
turn, an adjustment is necessary.
DO NOT OPERATE THE UNIT
UNTIL THE WHEEL BRAKE
MECHANISM HAS BEEN
ADJUSTED AND IS WORKING
PROPERLY. See "Wtleel Brake
Adjustment" in "Customer Respon-
sibilities."
WARNING
Do not use the mower if the
wheels continueto turn after
releasing the Operator Pres-
ence Control and the Wheel
Drive Control. Severe per-
sonal injury or property dam-
age could result if this in-
structionis notfollowed.
WARNING
The control rodsare adjusted
at the factory and should not
require additionaladjustment
during assembly. After
assembling unit, control rod
adjustment should be
checked (and re-adjusted, if
necessary) according to
informationin "Customer Re-
sponsibilities" Section. Se-
vere personal injury or prop-
erty damagecouldresultfrom
not following this
instruction.
STEP3: CheckTire Pressure
• Use a tire gauge to check the air
pressure in the rear tires. The air
pressure should be between 15-20
PSI (20 PSI maximum).
• Keep both tires equally inflated
to help prevent machine from
pulling to one side.
STEP4: After Assemblingand
BeforeUsingUnit
• Read this entire Owner's Manual
for proper safety, operation and
maintenance information.
• Make sure spark plug wire is
connected to spark plug before
starting unit.
IMPORTANT: MOTOR OIL MUST
BE ADDED TO THE ENGINE
CRANKCASE BEFORE START-
ING THE ENGINE. OIL FILLING
INSTRUCTIONS ARE COVERED
IN THE "OPERATION" SECTION.
CAUTION
Unit is shipped wiihoutoil in
engine crankcase. DO NOT
start engineuntil oil has been
added. Severe engine dam-
age will result if this instruc-
tion is not followed. See "Op-
eration" Section of this man-
ual for oil filling procedure.
12