Filter
Top Products
OPERATION
EngineThrottle Control
This lever (F, Figure 3-8) is used
to adjust engine speeds and to
stop the engine. Always run en-
gine at fast speed setting for best
mower performance. The throttle
settings are shown to the right.
]_1_1 CHOKE- Usewhen
startinga coldengine.
FAST- Use duringmower
operation. _
SLOW- Usewhenidling
engine.
'_ STOP- Stopsengine.
F- THRoJiLECONTROL
J
Figure 3-8
EngineRecoil Starter
The engine recoil starter (H, Fig-
ure 3-9) is used to "pull-start"the
engine. Do not pull the recoil
starter until you have read the Oper-
ation Section.
BEFOREOPERATING
Pre-Operation
Checklist
Perform the following checks before each use of your
machine:
ISlReview: "Safety" and "Operation" sections of manual.
Q Check for loose or missing hardware. Tighten or replace
before starting engine.
Q Check the engine oil level. Refer to "Customer Respon-
sibilities" section for instructions.
ISICheck the fuel level in the fuel tank (refer to next page
for instructions).
Q Check all levers for freedom of movement. Do not start
engine if any lever does not function correctly.
Adjust the blade cutting height (refer to this Section for
instructions).
Inspect the area to be mowed and remove any debris.
Check that all guards and shields are in place and prop-
erly secured.
_1 Check the installation of the mulcher cover in the right
side deck opening. Remove the mulcher cover if you
want to side d!scharge the grass.
I_1Check air pressure in rear tires at first use and every 25
operating hours. Maintain 15-20 PSI (maximum 20 PSI)
in each tire. Keep tires inflated equally or mower may
pull to one side.
ISIAttach the spark plug wire to the spark plug.
H - RECOIL
STARTER
Figure 3-9
16