Filter
Top Products
NOTE: If the cables have become dis-
connected, connect cables as shown in
Figure 7.
Traction DriveCable AugerDriveCable
Figure7
HOW TO ASSEMBLE THE CHUTE DEFLECTOR
1. Remove the carriage boll See
Figure 8.
2. Raise the chute deflector into op-
erating position.
3. Fasten chute deflector to flange
with carriage bolt. Make sure to
install with head of carriage bolt on
the inside of the flange.
4. Fasten with washer and Iocknut.
5. "Rghten Iooknut securely.
NOTE: Make sure all cerriage
bolts in flange are tight. DO NOT
OVERTIGHTEN.
De_ector
j T=z=._._Jj...... __
Nut / -- _, Operatng_l
I I Iii I _o_.oo-I
/k. ,--.or
Figure8
HOW TO SET THE SKID HEIGHT
Your snow thrower is equipped with
height adjust skids on the outside of the
auger housing. To adjust the skid
height for different conditions, see To
Adjust Skid Height paragraph In the
Service And AdJust_nent section.
HOW TO SET THE LENGTH OF THE CABLES
The cables were adjusted at the factory
and no adjustments should be neces-
sary. However, al_erthe handles are put
in the operating position, the cables can
be too tightor too loose. If an adjust-
ment is necessary, see =How To Check
And Adjust The Cables" in the Service
And Adjustment section.
F-O410111L 9