Filter
Top Products
TO ASSEMBLE THE HANDLE AND
CRANK ASSEMBLY
1. Cut tie holdingshift rod to lower
handle and move shifterto the first
forward gear.
2. Cut and discardthe plastic tie that
secures the crank assembly.
3. Loosen, but do not remove, the
screws, f_twashers, Iockwashers,
and hex nuts in the upper holes of
the lower handle. See Figure 3.
4. Remove the fasteners and the eye-
boltfrom the lower holes of the low-
er handle See Figure 5.
Right Hand Side j
OfUpperHandle_
5/16" Hex Nut_:_
/
LooseN_
but do not
remove
11/32"
Ratwasher
Rgum 3
NOTE: Make sure the cables are
not caught between the upper and
lower handle,
5. Raise the upper handle into operat-
ing position,
NOTE: If the cables have become dis-
connected form the drive levers, rein-
stall the cables as shown in Figure 4.
6. Install the fasteners that were re-
moved instep 4. DO NOT tighten
until all bolts are in place.
LeftSideOf
Upper
3/8= Nylon
Locknut
Eye Bolt Ratwasher
Rgure5
7. Attach the crank rod to the universal
joint assembly with the hair pin. See
Figure 6.
8. "lighten nut on eye bolt. Make sure
eye bolt is properly aligned and the
crank can fl'eely route.
9. Tighten all handle and panel bolts.
Cren_ Aod
Figure6
Coht_4 Cable Rgure 4
F-0410111L 8