Filter
Top Products
11. Remove the three fasteners that
hold the frl_ion wheel to the hub
(see Figure 43).
12. Remove the friction wheel from the
hub. Slip the friction wheel off the
hex shaft.
13. Assemble the new frletlon wheel
onto hub with the fasteners re-
moved earlier.
14. Install the hex shaft and bearings
with the four bolts removed eadier
(see Figure 44).
Make sure the washers are prop-
erly Installed in the original posi-
tion. Also, make sure the two
washers are properly aligned
w/th the actuator arms.
15. Make sure the hex shaft turns free-
ly.
16. Install the left wheel, axle, and
drive sprocket with the fasteners
removed earlier, install the chain
onto the drive sprocket (see
Figure 41).
17. Check the adjustment of the friction
wheel. See =How To Adjust The
FrictionWheel" in this section.
18. Make sum the friction wheel end the
disc drive plate are free from grease
or oil.
19. Install the bottom panel (see
Figure 40).
20. "13ghtenthe bolts on each side of
the bottom panel.
21. Installthe right wheel to the axle
with the fasteners removed earlier.
22. Connect the spark plug wire.
Friction
Fasteners Hub Wheel
Fasteners
Figure43
ActuatorArms
Beadngs
\
\
Washer
/
Washer
,/ Washer
Figure 44
F..0410111L 31