Filter
Top Products
HOW TO REMOVE
THE SNOW HOOD
To access the spark plug,the snow
hood must be removed as follows:
1. Remove the choke controlknob
(see Figure 21).
2. Remove the safety key.
3. Remove the mounting screws
(see Figure 22).
4. Slowly remove the snow hood.
Make sure that the primer button
hose and the Ignition wire are not
disconnected.
5. The spark plug can now be ac-
cessed.
6. To installthe snow hood, first make
sure that the primer button hose
and the ignitionwire are connected.
7. Mount the snow hoodto the engine
and secure with the mounting
screws (see Figure 22).
8. Connect the choke control knob
with the choke shaft on the carbure-
tor (see Figure 23 and Figure 24).
Make sure the choke control knob is
properly installed. If the choke con-
trol knob is not installedcorrectJy,
the choke will not operate.
9. Install the safety key.
Snow Hood
Spark k
P_
Choke
Control Knob
MountingScrews
22
Choke
ChokeShah
F_ure 23
Cafouretor
Figure 24
Rgure21
F-0410111L 22