Filter
Top Products
,_ WARNING: Always wearsafety glasses or eye shields
while assembling snow
thrower.
TOOLS REQUIRED FOR
ASSEMBLY
1 - Knifeto outcarton
2 - 1/2 inch wrenches
(or adjustable wrenches)
2 - 9/16 inch wrenches
(or adjustable wrenches)
2 - 3/4 inch wrenches
(or adjustable wrenches)
1 - Pliers (to spread cotter pin)
1 - Screwdriver
1 - Measuring tape or ruler
Figure1
Figure 1 shows the snow thrower in the
shipping position.
Figure 2 shows the snow thrower com-
pletely assembled.
References to the right or left hand side
of the snow thrower are from the view-
point of the operator's positionbehind
the unit.
TO REMOVE SNOW THROWER
FROM CARTON
1. Locate all parts packed separately
and remove from the carton.
NOTE: Place fuel stabilizer in a
safe place until needed for storage.
2. Remove and discard the packing
material from around the snow
thrower.
3. Cut down all four comers of the car-
ton and lay the panels fiat
4. Cut the straps that secure the axle
to the pallet,
5. For shipping purposes, the height
adjust skids are attached to the
pallet. Remove the screw that se-
cures each height adjust skid to
the pallet. See F'_jure2.
. Roll snow thrower off the pallet by
pulling on the lower handle. CAU-
TION: DO NOT back over contTol
cables.
7. Remove all packing material from
the unit.
8. Cut ties secudng the clutchcontrol
cable to the lower handle and lay
F-0410111L
cable back away from the motor
frame.
AugerDdveLever
Traction
DriveLever
Cable
k Assembly
Chute
Lever
7
Screw Figure 2