Filter
Top Products
2009 Portable Spa
LTR20091000, Rev. A
Clear Water Plan
www.calspas.com
25
This applies to all spa owners EXCEPT those with
the Cal Clarity bromine generator. See instructions
on page page 27 for bromine generator operating
instructions and spa lling procedures.
We recommend you use Cal Spas chemicals only.
Other brands of chemicals may have similar names
and/or usage descriptions but due to manufacturing
differences, use of other chemicals can increase
the likelihood of under- or over-dosing the spa
chemicals. Damage to the spa or spa’s components
from improper chemicals or chemical usage is not
covered under the spa’s warranty.
Prior to lling a spa for the rst time, or after a routine
draining, you will want to follow this start-up plan to
extend water life and performance.
As with all chemical dosages listed in these Clear
Water Plans, start-up dosages are intended for
500-gallon spas. Please adjust the chemical dosages
to the capacity of your particular spa.
Clean the surface of the spa with Cal Spas “Multi-1.
Purpose Cleaner”.
Apply a protective coat of Cal Spas “Fast Sheen” 2.
to the acrylic surface.
Fill the spa to the proper water level with normal 3.
tap water. (Do not use soft water.)
Use test strip and balance the spa water.4.
Adjust total alkalinity (acceptable range is •
80-120ppm).
Adjust pH if necessary (between 7.2 to 7.8).•
Pour in 16 oz of Cal Spas “Metal Protector” in the 5.
center of the spa.
Add Stain and Scale Prevention.6.
Add either chlorine or bromine (but not both).7.
Chlorine: Add two tablespoons of Cal Spas “Chorine
Granules” to the spa water.
Bromine: Add 2 oz of Cal Spas “Go Brom” to
establish a bromine base.
Add 2 Cal Spas “Bromine Tablets” to
bromine oater.
Set oater opening at #2.
Turn on jets for 15 minutes. Leave spa uncovered 8.
during this time.
Put cover on spa and allow to heat up to desired 9.
temperature.
Starting the Spa with Fresh Water
Water level is very important to the operation of your spa. If the water level
is too low or too high, your spa will not operate properly. The water level
should be about six inches from the top when the spa is not being used.